klogd 1.4.1#2, log source = /proc/kmsg started.
Inspecting /boot/System.map-2.4.7
Loaded 18375 symbols from /boot/System.map-2.4.7.
Symbols match kernel version 2.4.7.
No module symbols loaded.
Linux version 2.4.7 (root@petunia) (gcc version 2.95.4 20010721 (Debian prerelease)) #1 Sun Aug 5 20:37:15 EDT 2001
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000004000000 (usable)
 BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
Scan SMP from c0000000 for 1024 bytes.
Scan SMP from c009fc00 for 1024 bytes.
Scan SMP from c00f0000 for 65536 bytes.
Scan SMP from c009fc00 for 4096 bytes.
On node 0 totalpages: 16384
zone(0): 4096 pages.
zone(1): 12288 pages.
zone(2): 0 pages.
mapped APIC to ffffe000 (01111000)
Kernel command line: BOOT_IMAGE=Linux ro root=30c hdd=ide-scsi, max_scsi_luns=1
ide_setup: hdd=ide-scsi,
Initializing CPU#0
Detected 360.825 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 719.25 BogoMIPS
Memory: 61144k/65536k available (1693k kernel code, 4004k reserved, 682k data, 260k init, 0k highmem)
Dentry-cache hash table entries: 8192 (order: 4, 65536 bytes)
Inode-cache hash table entries: 4096 (order: 3, 32768 bytes)
Mount-cache hash table entries: 1024 (order: 1, 8192 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 16384 (order: 4, 65536 bytes)
CPU: Before vendor init, caps: 0183f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 512K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0183f9ff 00000000 00000000 00000000
CPU:     After generic, caps: 0183f9ff 00000000 00000000 00000000
CPU:             Common caps: 0183f9ff 00000000 00000000 00000000
CPU: Intel Pentium II (Deschutes) stepping 03
Enabling fast FPU save and restore... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb460, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.14)
Starting kswapd v1.8
VFS: Diskquotas version dquot_6.4.0 initialized
Coda Kernel/Venus communications, v5.3.14, coda@cs.cmu.edu
udf: registering filesystem
parport0: PC-style at 0x378 [PCSPP,TRISTATE,EPP]
parport0: cpp_daisy: aa5500ff(98)
parport0: assign_addrs: aa5500ff(98)
parport0: Printer, HEWLETT-PACKARD DESKJET 610C
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS01 at 0x02f8 (irq = 3) is a 16550A
lp0: using parport0 (polling).
block: queued sectors max/low 40525kB/13508kB, 128 slots per queue
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100%% native mode: will probe irqs later
    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA
hda: ST36422A, ATA DISK drive
hdb: Maxtor 83500D4, ATA DISK drive
hdc: FX4010M, ATAPI CD/DVD-ROM drive
hdd: PCRW804, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 12500460 sectors (6400 MB) w/256KiB Cache, CHS=778/255/63, UDMA(33)
hdb: 6839440 sectors (3502 MB) w/256KiB Cache, CHS=7237/15/63, UDMA(33)
hdc: ATAPI 40X CD-ROM drive, 256kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
 hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 hda11 hda12 hda13 hda14 >
 hdb: [PTBL] [848/128/63] hdb1
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
SLIP: version 0.8.4-NET3.019-NEWTTY (dynamic channels, max=256) (6 bit encapsulation enabled).
CSLIP: code copyright 1989 Regents of the University of California.
SLIP linefill/keepalive option.
loop: loaded (max 8 devices)
plip: parport0 has no IRQ. Using IRQ-less mode,which is fairly inefficient!
NET3 PLIP version 2.4-parport gniibe@mri.co.jp
plip0: Parallel port at 0x378, not using IRQ.
PCI: Found IRQ 10 for device 00:0d.0
3c59x.c:LK1.1.15 6 June 2001  Donald Becker and others. http://www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
00:0d.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xe800,  00:50:04:d1:8b:a1, IRQ 10
  product code 544a rev 00.12 date 06-20-99
  8K byte-wide RAM 5:3 Rx:Tx split, autoselect/Autonegotiate interface.
  MII transceiver found at address 24, status 786d.
  Enabling bus-master transmits and whole-frame receives.
00:0d.0: scatter/gather enabled. h/w checksums enabled
PPP generic driver version 2.4.1
PPP Deflate Compression module registered
PPP BSD Compression module registered
Universal TUN/TAP device driver 1.4 (C)1999-2001 Maxim Krasnyansky
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 28M
agpgart: Detected Intel 440BX chipset
agpgart: AGP aperture is 64M @ 0xe0000000
[drm] AGP 0.99 on Intel 440BX @ 0xe0000000 64MB
[drm] Initialized tdfx 1.0.0 20000928 on minor 63
[drm] AGP 0.99 on Intel 440BX @ 0xe0000000 64MB
[drm] Initialized radeon 1.0.0 20010105 on minor 62
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
es1371: version v0.30 time 20:44:43 Aug  5 2001
PCI: Found IRQ 5 for device 00:0b.0
es1371: found chip, vendor id 0x1274 device id 0x1371 revision 0x06
es1371: found es1371 rev 6 at io 0xe400 irq 5
es1371: features: joystick 0x0
ac97_codec: AC97  codec, id: 0x5452:0x4123 (TriTech TR?????)
Linux telephony interface: v1.00
$Id: ixj.c,v 3.31 2000/04/14 19:24:47 jaugenst Exp $
md: linear personality registered
md: raid0 personality registered
md: raid1 personality registered
md: raid5 personality registered
raid5: measuring checksumming speed
   8regs     :   597.600 MB/sec
   32regs    :   442.400 MB/sec
   pII_mmx   :   809.200 MB/sec
   p5_mmx    :   843.200 MB/sec
raid5: using function: p5_mmx (843.200 MB/sec)
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
LVM version 0.9.1_beta2  by Heinz Mauelshagen  (18/01/2001)
lvm -- Driver successfully initialized
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 4096 bind 4096)
IPv4 over IPv4 tunneling driver
ip_conntrack (512 buckets, 4096 max)
ip_tables: (c)2000 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 260k freed
Adding Swap: 265032k swap-space (priority -1)
eth0: using NWAY device table, not 8
plip0: transmit timeout(1,de)